The runners shall be Glass Filled Polymer with ends of the runners beveled to facilitate installation over rough weld beads or the weld ends of misaligned or deformed casing pipe. The runners shall be attached to support structures (risers) at appropriate positions to properly support the carrier pipe within the casing and to ease installation. They shall have a minimum length of 7.0 in. and a minimum width of 2.0 in.
The shell shall be manufactured of 8.0 in. wide, 14-gauge T-304 stainless steel. The riser shall be constructed of 10-gauge T-304 stainless steel, 6.75 in. minimum lengths with a height to be determined based on the annular space between the carrier pipe OD and the casing ID.
Recommended positioning of the spacers is one placed 1-2 feet on either side of the bell joint and one every 6-8 feet apart thereafter for a total of three casing spacers per joint. CCI engineering reserves the right to recommend spacing according to application.
PHYSICAL PROPERTIES |
|
SHELL and RISERS |
LINER- EPDM Thickness: .090" (2.29mm) Minimum Hardness: Durometer Shore 'A' 85-90 Dielectric Strength: {1/8" (3.18mm) thick} 60,000 VPM Water Absorption: 1 % Maximum Overlaps edges |
FINISH 2B Finish |
ASSEMBLY HARDWARE Bolts: 5/16"-18UNC x 2" Long Stainless Steel Nuts: 5/16" Stainless Steel Hex Nuts Washers: 5/16" Stainless Steel SAE 2330 |
RUNNERS 2" Wide Glass Filled Polymer Length: 7" (177.8 mm) Minimum Tensile Strength: ASTM D 638 27.0 kpsi Compressive Strength: ASTM D 695 33.0 kpsi Flexural Modulus: ASTM D 790 1,300 kpsi Izod Impact @ 73°F (23°C): 11 kJ/m2 Melting Point: ASTM D 3418 504°F (263°C) |
WELDING All risers shall be welded to the shell by MIG welding. All welds are to be fully passivated. |
CCI Pipeline Systems certifies the Model CSSB stainless steel casing spacers are of the highest quality which meet or exceed industry standards. |
Hours of operation: Monday through Friday 8:30 A.M. to 5:00 P.M. EST